Monster Hunter
11-20-2008, 04:23 PM
Hey in case y'all didnt know i have a website for the psp. Instead of advertising I will just post the guides here! That way we can all be on one forum and you can hack your psp. O btw can i be banned for posting guides from my website? I dont want to advertise I just want to help people with there tech problems with the psp.
First guide: Installing cfw (custom firmware) You will need this to play any of the games I post here, and hombrew.
-----------------------------------------------------------------------------
First you will need a pandoras battery. There are two ways of doing this.
#1 Hard-modding
#2 Soft Modding
Soft Modding is easy, but hard modding is hard. If you know somebody that has custom firmware (cfw) installed they can help you create a soft modded pandoras battery. I will show you how to make a hard modded battery. I have had bad experiences soft modding a battery. SO BE WARNED!!
You will need to have these materials to make a hard modded battery: A sharp knife, a safety pin, and a real Sony psp battery. You will need a safety pin because they are small and a normal pin won't work. Take your knife and cut through the sides of the battery. Make sure you go through the plastic because you will be opening it up. Don't cut yourself I have done that carelessly before, this takes time about 15-30 min. of cutting depending on how good your knife is. If you start to lose patience, just set it down and relax for awhile. It gets frustrating! The top part of the battery will come off after you cut it open. Take out the 4th pin here is a link to a picture that shows you where the 4th pin is. They will look different depending on what battery you are using.
Here is the PSP Slim battery pic.
http://i177.photobucket.com/albums/w206/x70andrew07x/slim.jpg
Here is the Original PSP battery pic.
http://www.techknowsupport.com/brin/files/battery_phat_pinfive.png
Take the safty pin and lift up under the circled pin until it pops out.
If you open your psp battery up and then you see this on the top of the battery then ask me for help. I tried to get a picture of that battery I just couldn't find one. My advice for a pandoras battery, would to have two battery's because when you "pandoraize" your battery you cannot use it as a normal battery ever again. If you plug you psp into a wall using the charger WITHOUT the modded battery in, turn it on and then put the battery in you can use you battery normally until you turn it off.
After you have modded your battery it is now officially a PANDORAS BATTERY!!!
NOTE: your memory card HAS to be Sony and it needs to be more 512mb or it WILL NOT work!!
To install the firmware you need a program on your memory card. This program makes your memory card a "Magic Memory Stick" or mms.
First you need this file:
http://www.zshare.net/download/506425677b8933d2/
after you have the downloaded files we will make a magic memory stick! ( the easiest part)
- extract the The File You Need.7z to your desktop (use WinRAR)
- Open README 1st folder
- highlight and copy MSINST and MSPFORMAT FOLDER
- open My Computer
- Left Click the C: drive once (Note: if you double click, it will open C: drive)
- Now RIGHT Click on C: drive and PASTE
- format your memory stick thru your psp (Settings>System Settings>Format Memory Stick)
- once that is done, enable USB mode
- make note of your drive letter (usually E: or F)
- open up command propmt (click Start, select Run, type in cmd and hit enter_
- Type in the following command "CD C:\" (note: with-out quote mark) HIT enter
- type the following command "mspformat\mspformat.exe X" ( where X=psp drive letter) note: NO quotation
- hit enter button
- hit Y, then press enter
(for some people who are confused on this part, here is a side note: guess i wasnt clear enough, you type mspformat\mspformat.exe E if your drive letter is E, if it is another letter use that letter, then press enter, then hit y, then press enter again...sorry
- it should say "Drive succesfully formatted, and partition moved."
- disable USB mode, and take out the memory stick
- now re-insert the memory stick, and re-enable(this guide was made by hercules on pspmod.com) USB mode
- Now go back to the Desktop where you extracted the folder "The File You Need"
- double click it
- open the Despertar v3 folder, and copy its contents to your psp (just the contents, not the actual folder)
- now go back to your prompt window
- type the following command "msinst\msinst.exe X msinst\msipl.bin" (again where X=psp drive letter) note: NO quotation
- press Y and hit enter
- The last line should say " Write MS BOOT CODE "
- then type exit and enter
* you now have a magic memory stick!
Okay now you are ready to install cfw!!!! You made it this far so lets see if you did everything right. If it doesn't work then ask me any questions you have and I will try to answer them all.
Okay so first charge your battery for a while (without the memory card in). After about a hour or so depending on how full your battery is It is time! (your battery has to be at 78%) Pop in the pandoras battery, then put the battery cover on you DON'T want the battery to fall out!! Put in the magic memory stick. If you see a menu come up that makes you feel more NERDY than you were before... THEN YOU ARE GENIUS!!! Okay press the "x" button. See that text FLYING down your screen? (loading PSAR to RAM takes the longest, so if you see the orange lite flashing at the opposite of you power button. It is working) Then IT WORKS!!! yay!!!
Keep looking to see " install complete press X to restart" Well press X
After this whole process is complete, the PSP should restart. Put in normal battery and then check your psp's firmware. It should be 3.71 m33-2.
First guide: Installing cfw (custom firmware) You will need this to play any of the games I post here, and hombrew.
-----------------------------------------------------------------------------
First you will need a pandoras battery. There are two ways of doing this.
#1 Hard-modding
#2 Soft Modding
Soft Modding is easy, but hard modding is hard. If you know somebody that has custom firmware (cfw) installed they can help you create a soft modded pandoras battery. I will show you how to make a hard modded battery. I have had bad experiences soft modding a battery. SO BE WARNED!!
You will need to have these materials to make a hard modded battery: A sharp knife, a safety pin, and a real Sony psp battery. You will need a safety pin because they are small and a normal pin won't work. Take your knife and cut through the sides of the battery. Make sure you go through the plastic because you will be opening it up. Don't cut yourself I have done that carelessly before, this takes time about 15-30 min. of cutting depending on how good your knife is. If you start to lose patience, just set it down and relax for awhile. It gets frustrating! The top part of the battery will come off after you cut it open. Take out the 4th pin here is a link to a picture that shows you where the 4th pin is. They will look different depending on what battery you are using.
Here is the PSP Slim battery pic.
http://i177.photobucket.com/albums/w206/x70andrew07x/slim.jpg
Here is the Original PSP battery pic.
http://www.techknowsupport.com/brin/files/battery_phat_pinfive.png
Take the safty pin and lift up under the circled pin until it pops out.
If you open your psp battery up and then you see this on the top of the battery then ask me for help. I tried to get a picture of that battery I just couldn't find one. My advice for a pandoras battery, would to have two battery's because when you "pandoraize" your battery you cannot use it as a normal battery ever again. If you plug you psp into a wall using the charger WITHOUT the modded battery in, turn it on and then put the battery in you can use you battery normally until you turn it off.
After you have modded your battery it is now officially a PANDORAS BATTERY!!!
NOTE: your memory card HAS to be Sony and it needs to be more 512mb or it WILL NOT work!!
To install the firmware you need a program on your memory card. This program makes your memory card a "Magic Memory Stick" or mms.
First you need this file:
http://www.zshare.net/download/506425677b8933d2/
after you have the downloaded files we will make a magic memory stick! ( the easiest part)
- extract the The File You Need.7z to your desktop (use WinRAR)
- Open README 1st folder
- highlight and copy MSINST and MSPFORMAT FOLDER
- open My Computer
- Left Click the C: drive once (Note: if you double click, it will open C: drive)
- Now RIGHT Click on C: drive and PASTE
- format your memory stick thru your psp (Settings>System Settings>Format Memory Stick)
- once that is done, enable USB mode
- make note of your drive letter (usually E: or F)
- open up command propmt (click Start, select Run, type in cmd and hit enter_
- Type in the following command "CD C:\" (note: with-out quote mark) HIT enter
- type the following command "mspformat\mspformat.exe X" ( where X=psp drive letter) note: NO quotation
- hit enter button
- hit Y, then press enter
(for some people who are confused on this part, here is a side note: guess i wasnt clear enough, you type mspformat\mspformat.exe E if your drive letter is E, if it is another letter use that letter, then press enter, then hit y, then press enter again...sorry
- it should say "Drive succesfully formatted, and partition moved."
- disable USB mode, and take out the memory stick
- now re-insert the memory stick, and re-enable(this guide was made by hercules on pspmod.com) USB mode
- Now go back to the Desktop where you extracted the folder "The File You Need"
- double click it
- open the Despertar v3 folder, and copy its contents to your psp (just the contents, not the actual folder)
- now go back to your prompt window
- type the following command "msinst\msinst.exe X msinst\msipl.bin" (again where X=psp drive letter) note: NO quotation
- press Y and hit enter
- The last line should say " Write MS BOOT CODE "
- then type exit and enter
* you now have a magic memory stick!
Okay now you are ready to install cfw!!!! You made it this far so lets see if you did everything right. If it doesn't work then ask me any questions you have and I will try to answer them all.
Okay so first charge your battery for a while (without the memory card in). After about a hour or so depending on how full your battery is It is time! (your battery has to be at 78%) Pop in the pandoras battery, then put the battery cover on you DON'T want the battery to fall out!! Put in the magic memory stick. If you see a menu come up that makes you feel more NERDY than you were before... THEN YOU ARE GENIUS!!! Okay press the "x" button. See that text FLYING down your screen? (loading PSAR to RAM takes the longest, so if you see the orange lite flashing at the opposite of you power button. It is working) Then IT WORKS!!! yay!!!
Keep looking to see " install complete press X to restart" Well press X
After this whole process is complete, the PSP should restart. Put in normal battery and then check your psp's firmware. It should be 3.71 m33-2.